搜索结果: 1-6 共查到“exhaust gas”相关记录6条 . 查询时间(0.061 秒)
Laboratory Scale of Liquid Coal Fuel Combustion Process and Exhaust Gas Formation
Coal oil furnace combustion exhaust gas
2010/12/22
New way for preparation for liquid coal oil steady combustion on a 2.75 m horizontal boiler with four annular segment tubes, a water jacket system and a system for measurement of water temperature ins...
Effect of Exhaust Gas Recirculation (EGR) on the Performance and Emission Characteristics of Diesel Engine with Sunflower Oil Methyl Ester
Emission Exhaustgas Recirculation Sunflower Oil
2010/1/15
Transesterified fuels (biodiesel) from vegetable oils are alternative fuels for diesel engines. They are renewable and offer potential reduction in CO and HC emissions due to higher O2 contents in veg...
Experimental Analysis of the Effect of Exhaust Gas Recirculation (EGR) on Engine Performance and Exhaust Emissions on Diesel Engines
Dizel motoru Dizel emisyonu EGR Egzoz emisyon kontrolu
2009/10/13
Experimental Analysis of the Effect of Exhaust Gas Recirculation (EGR) on Engine Performance and Exhaust Emissions on Diesel Engines。
测量排气流量的内锥流量计数值模拟与实验（Numerical and Experimental Study on V-cone Flowmeter for the Vehicle Exhaust Gas Flow Measurement）
内锥流量计 流量测量 碳平衡法
2009/8/11
为了保证碳平衡法测量实车油耗的精度，对油耗测量系统中的内锥流量计进行了特性研究。用Fluent软件对内锥流量计进行了数值模拟，研究不同等效直径比、前后锥角、有无连接支撑杆等几何参数以及雷诺数对内锥流量计永久压力损失和流出系数的影响规律；将设计的两种内锥流量计与标准临界文丘里管组进行了对比验证实验，并以文丘里管实测值为参考值，得出了计算流出系数的拟合公式，将此拟合公式作为流量计算模型。结果表明数值模...
Longpath DOAS tomography on a motorway exhaust gas plume: numerical studies and application to data from the BAB II campaign
Longpath DOAS tomography motorway exhaust gas plume numerical studies BAB II campaign
2009/3/4
This paper presents a procedure for performing and optimizing inversions for DOAS tomography and its application to measurement data. DOAS tomography is a new technique to determine 2- and 3-dimension...
Oxidation and exhaust gas corrosion resistance of the cobalt base clad layers
Gas corrosion Oxidation resistance Cobalt-base alloy
2010/1/19
Purpose: Purpose of this work is describing the behaviour of the cobalt base cladding layers after treatment in
hot air (750°C, 200 hours) and exhaust gases (700°C, two month).
Design/methodology/ap...